SurfBoard Quick Start Guide
|
|
Step 3 Press [1].The SurfBoard will respond with the following options: To search for your TV press 1. To program a TV from the device list press 2. Step 4. Press [1]. The SurfBoard will respond with: Please turn your TV on. When it turns off, press POWER. To search for your TV by brand, enter the 2 digit brand code. For example if you have a Sony TV, type in [5]-[9]. If your brand is not listed, press [MUTE/ENTER]to search through all TVs. The SurfBoard will say, searching for TVs.. You will hear the 3 digit device code for each TV code it tries before sending out the power code. After each code is sent, it will wait 4 seconds for you to respond before trying the next code. Step 5. When your TV turns off, press any front button except [SHIFT] to save the code. If your brand of TV is not listed, you can search through al the TV codes. For alternate set up methods including learning codes from your original equipment remote, please see the Users Guide. |
Step 6. Using the same method you used to set up your TV, you can set up the SurfBoard remote to control your cable or satellite box. The sequence for setting up your cable or satellite box by searching just your brand of cable or satellite box is: [HELP]-[2]-[1]-[2 digit brand code] The sequence for searching through all cable and satellite receivers is: [HELP]-[2]-[1]-[MUTE/ENTER] Since some cable and satellite boxes have no power button, the SurfBoard will send a channel-up command when searching for cable or satellite boxes.
|
